Wikia

Solar Cookers World Network

Pot-in-pot cooler

Talk2
1,862pages on
this wiki
Revision as of 21:21, April 29, 2013 by Tom Sponheim (Talk | contribs)


The Pot-in-pot Cooler, based on by ancient techniques, was designed by Mohammed Bah Abba who won the Rolex prize and who has been promoting this process though-out Nigeria. The concept takes advantage of evaporative cooling. Two terra-cotta pots are used, one inside the other, allowing for approximately a 3-4cm(1.5-2in.) gap between the smaller and the larger pot. The gap is filled with sand and then saturated with water. Some of the water will seep into the clay pots as well.

Fruits and vegetables are placed inside the small pot, and the cooler is covered with a wet towel. As the water slowly evaporates from the cooler, heat is taken from clay pots, keeping the food a cool temperature inside. Water will need to be added to the sand depending upon the air temperature outside. Left in the shade, the Pot in Pot Cooler will keep foods fresh for some time.

I decided to make a “pot-in-pot” cooler and here are photos of it. The basic unit has two large unglazed pottery pots which I commissioned to be made without bottom holes by Panama Pottery in Sacramento. One pot fits inside the other with a layer of sand in between the pots. Alternately, I could have used normal pots and sealed their holes with wax or waterproof tape.

Pot in pot cooler 1

I am using my watering pot here to wet the sand layer, which I do every morning. Inside the inner pot, there is a watermelon, a cabbage, a bag of carrots and two apples.

Pot in pot cooler 2

I have a folded towel on top of the pots and produce and I am wetting the towel to provide additional evaporation through the cloth top. I moisten the cloth twice a day.

Folsom, California, is typically hot in the summer, but this is an exceptionally hot day at 109°F in the shade. It is an excellent opportunity to test this cooler.

Pot in pot cooler 3

Here the temperature inside the pot is 74°F degrees. It is 35°F degrees cooler inside the pot than outside. I have now had these fruits and vegetables in the device for a week and they are perfectly fresh. The daytime outside temperature has varied this week from the high of 109°F degrees to 90°F degrees and the temperature inside the pot has varied from 75°F degrees to 62°F degrees.

Pot in pot cooler 4

If you would like to learn more about this device, go to http://rolexawards.com/en/the-laureates/mohammedbahabba-the-project.jsp

Carol Veder

Sharon Cousins discovered that it is important to weight the inner pot when initially moistening the sand or it will try to float and the sand will slip and pile up underneath. This is a very effective way of keeping vegetables fresh. Sharon bought large plant pots on sale and used pieces of plastic jug glued on with Shoe Goo to seal the drain holes.

Audio and video

How to Make a Pot in Pot Cooler01:48

How to Make a Pot in Pot Cooler

Around Wikia's network

Random Wiki